Creality V2 2 Board Diagram __link__

JST connector (usually wired to be always on).

Supports dual Z-axis motors and dual extrusion setups with six stepper motor ports. Protection: Creality V2 2 Board Diagram

The Creality V2.2 diagram shows a specific 5-pin port labeled PROBE . However, many BL-Touch kits come with a 3-pin + 2-pin dupont cable. Connect as follows: JST connector (usually wired to be always on)

Main DC input from the power supply. Crucial: Ensure correct polarity. Red goes to Positive (+), Black goes to Negative (-). However, many BL-Touch kits come with a 3-pin

End of Paper

| Axis | Step Pin | Dir Pin | Enable Pin | Driver DIAG (unused) | |-------|----------|---------|------------|----------------------| | X | PB13 | PB12 | PC3 | - | | Y | PB10 | PB2 | PC2 | - | | Z | PB11 | PB1 | PC5 | - | | E0 | PB14 | PB0 | PC4 | - |