This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Once the top bar is secure, go back and fully tighten all base and frame bolts. 4. Pulleys and Cables Dp Dual Trac 20 Assembly Manual
Over time, brand-new steel cables will stretch slightly. If there is slack in the line when the weight stack pin is inserted: This public link is valid for 7 days
: The tracks use a V‑groove + ball bearing interface. If you tighten the carriage’s set screw (often labeled “C”) before inserting the bearing race, you will jam the vertical travel. The manual shows an exploded view of the bearing race sliding first , then the screw. In practice, 30% of user forum complaints about “stiff vertical adjustment” trace back to reversing these two sub‑steps. Can’t copy the link right now
Secure the tops of the weight guide rods to the rear brackets of the top crossmember. Tighten these upper connections hand-tight. Step 4: Seat and Backrest Bracket Installation
Align the bottom bracket of the vertical upright mast with the mounting holes on the base frame.
Allen (hex) keys (typically included, but a high-quality set prevents stripped bolts)