Hw 130 Motor Control Shield For Arduino Datasheet Better Direct

| Feature | Specification | | :--- | :--- | | | L293D (Dual Full H-Bridge) | | Motor Channels | 4 DC Motors or 2 Stepper Motors | | Servo Ports | 2 (Pins Digital 9 and 10) | | DC Current per Channel | 600mA (Continuous), 1.2A (Peak) | | Motor Supply Voltage | 4.5V to 24V DC | | Compatibility | Arduino Uno, Mega, Due, and others with standard pinout | | On-board 5V Regulator | Provides power to the Arduino (via PWR jumper) | | 74HC595 Shift Register | Reduces the number of pins needed for control |

with individual 8-bit speed selection (connected to terminals M1, M2, M3, M4). Up to 2 stepper motors (unipolar or bipolar). hw 130 motor control shield for arduino datasheet better

Up to with 8-bit speed selection. Up to 2 stepper motors (unipolar or bipolar). | Feature | Specification | | :--- |

#include <AFMotor.h>

The motors will run, but if they run opposite directions, swap the wires on that M1 or M2 terminal. Up to 2 stepper motors (unipolar or bipolar)

The HW-130's compact design is one of its best features, keeping wiring clean and simple.

The HW-130 is an architecture built around and a 74HC595 8-bit serial-to-parallel shift register . This combination allows you to multiplex your pins, controlling a high volume of inductive loads while conserving precious Arduino I/O. Adafruit Motor Shield